Wall Mounted Electrical Box
Not every disconnect belongs in the middle of the roof. Some of it has to go on the wall, beside a penthouse door, on a parapet, wherever the conduit already runs. That usually means a handful of fasteners driven through flashing with sealant over the top. The Wall Mounted Electrical Box attachment seals at every fastener with the same Compression-Free™ connection used on the deck, so the assembly stays intact.
Drag to turn it
A wall-mounted box on its Compression-Free™ attachment, on 2000 Series U-Anchors.
How it works
It starts with a U-Anchor®, a component of the roof, sealed watertight at the point of attachment. Everything else connects your equipment to that one point.
The part that carries the load. A galvanized steel plate with rolled edges that protect the membrane sits under a cover membrane matched to the roofing brand, type, and color, leaving a stainless stud at the surface for everything else to bolt to. Which one you use is decided by the membrane on the building, not by the equipment.
Horizontal strut support, Vertical strut, Electrical or control box (by others) — fitted to the equipment itself rather than to the roof.
