U2800-COATINGS
The U2800-Coatings is a lightweight rooftop attachment solution consisting of a U-Anchor 2000 Series plate and a reinforcement fabric. The U2800 includes a factory prepared reinforcement. The reinforcement is dependent on the type of coating being used, and therefore the method of installation may vary.
Advantages
Lightweight: 5 oz. (142 grams). Installs quickly, approximately rate of 12 per man hour. Installs on any surface from flat to vertical.
Box Dimesions
17'' x 17'' x 5''
Box Weight
Approx. 7 lbs
Equipment Attachment
To securely mount your rooftop equipment to the U-Anchor, after its installed, the connection nut must be fastened to approximately 20-25 torque pounds. Use a calibrated torque wrench during install to ensure appropriate results are achieved.
Fastener Material Type
304 Stainless Steel
Full Box Quantity
10 Units
Full Pallet Quantity
40 Boxes
Individual Weight
Approx. 0.5 lbs
Pallet Dimensions
48'' x 40'' x 52''
Plate Fastener Hole Diameter
17/64" (8 holes)
Plate Fastener Hole Pattern
0.047'' (1.194mm)
Plate Material Thickness
N/A
Plate Outer Diameter
5-1/2"
Ratings
Shear: 4000 lbs Tension: 3000 lbs
U-Anchor
Attachment
Attachment
The U2800-Coatings is attached by fastening through the roofing assembly into the structural decking with 2-8 approved fasteners. Depending on the roofing manufacturer's requirements, the reinforcement type may vary, thereby changing the method of installation. Consult the coating manufacturer for proper application instructions. Fastener selection is dictated by the system assembly, deck type, and the project engineer. Refer to installation instructions and the specified roofing material manufacturer requirements before installing.
Width
N/A
Video
Installation Video
LibraryFAQWarranty