U2400-TPO
.jpg)
The U2400-TPO is a lightweight rooftop attachment system consisting of a U-Anchor 2000 Series plate and cover membrane. The cover membrane is factory sealed to the top of the plate. The U2400-TPO provides a positive, watertight, manufacturer accepted attachment for mechanically attached and fully adhered TPO single-ply membranes.
Advantages
Extremely strong and lightweight. Fast installation, approximate rate of 12 per man hour. Installs on any surface from flat to vertical.
Box Dimesions
13'' x 11'' x 13''
Box Weight
Approx. 10 lbs
Equipment Attachment
To securely mount your rooftop equipment to the U-Anchor, after its installed, the connection nut must be fastened to approximately 20-25 torque pounds. Use a calibrated torque wrench during install to ensure appropriate results are achieved.
Fastener Material Type
304 Stainless Steel
Full Box Quantity
10 units
Full Pallet Quantity
50 boxes
Individual Weight
Approx. 0.75 lbs
Pallet Dimensions
48'' x 40'' x 67''
Plate Fastener Hole Diameter
17/64" (8 holes)
Plate Fastener Hole Pattern
4-1/8'' Diameter
Plate Material Thickness
0.047'' (1.194mm)
Plate Outer Diameter
5-1/2"
Ratings
Shear: 4000 lbs Tension: 3000 lbs
U-Anchor
Attachment
Attachment
The U2400-TPO is attached by fastening through the roofing assembly into the structural decking with 2-8 approved fasteners. The membrane cover is then hot air welded around the perimeter to the roof membrane. Fastener selection is dictated by the system assembly, deck type, and the project engineer. Refer to installation instructions and the specified roofing material manufacturer requirements before installing.
Width
11.75''
Video
Installation Video
LibraryFAQWarranty