U-Anchor 2600 Asphalt

SBS Adhered 1-Ply/2-Ply: $42.50

SBS Torch: $42.50

APP Torch: $42.50

Available for the following roofing manufacturers: Certainteed, Durbigum, Firestone, Generic, GAF, Garland, Johns Manville, Malarkey, Polyglass, Siplast, Soprema, Tremco, US-Ply

The U-Anchor 2600 Asphalt is a integrated solution for modified bitumen & built up roof applications, consisting of a U-Anchor plate with a 3/8”-16 X 1 3/8” Stainless steel stud and flashing. The plate is placed over the existing roofing and fastened to the structural roof deck. The factory supplied flashing is then sealed to the plate and the roof material creating a permanent seal. The flashing can be made from the same brand as the roofing material.Please specify a brand when possible. Nuts and lock washers sold separately. Alternate colors other than white are available on request.

Testing & Engineering Reports

Test 1Download Full Report

Test Load: 1968 lbs Shear (1211 lbs Tension)
Insulation Board: (Optional) Any UL classified min 1.5″ mechanically attached ISO board
Cover Board: Min ¼” – Dens-Deck Prime, Securock, or high density ISO board
Membrane: Any TPO or PVC roof membrane

Test 2Download Full Report

Test Load: 1968 lbs Shear (1211 lbs Tension)
Deck: Min ½” wood, metal, lightweight concrete, or structural concrete
Insulation Board: (Optional) Any UL Classified Min 1.5” mechanically attached ISO board
Cover Board: Min ¼” Dens-Deck Prime or Securock, or high density ISO board
Membrane: Any TPO or PVC roof membrane

Disclaimer: The attached information represents tension loads or loads applied to the product in an upward direction, perpendicular to the roof surface. Roof assemblies must be secured in accordance with typical roof industry installation practices and attachment patterns specified in the individual test report selected. Third party test reports are available for both tension as well as shear for each roof assembly. Loads are listed in ultimate force without the inclusion of a safety factor. Allowable loads should be calculated using a safety factor consistent with ASCE7 and ASTM D6630. Actual safety factor identification and overall force load calculations are the responsibility of the qualified design professional of record for each project.

Contact Us

© 2015- Anchor Products. All Rights Reserved.
Designed by Colorado Springs SEO

Anchor Products

P.O. Box 1551
Colleyville, TX 76034
United States

T  888-575-2131
E info@162.241.170.148
E orders@162.241.170.148