The U3800-S Coatings is a lightweight rooftop attachment solution consisting of a U-Anchor 3000-S Series plate and a reinforcement fabric. The U3800-S includes a factory prepared reinforcement. The reinforcement is dependent on the type of coating being used, and therefore the method of installation may vary.
- 3/8″-16 x 1.5″ Attachment Bolt*
- Material Type: 304 Stainless Steel
- Dimensions: 8.128” x 5.47”
- Fastener Hole Diameter: 17/64’’ (12 holes)
- Material Thickness: 0.047’’ (1.194mm)
- Material Type: Galvalume® AZ55
- Manufacturer: Brand Specific OR Generic
- Color: Default White*
- Length: 14.75’’
- Width: 11.75’’
- Visit www.anchorp.com/patents
Sold Individually OR Full Box Quantity
- Individual Weight: Approx. 0.5 lbs
- Full Box Quantity: 10 units
- Box Weight: Approx. 5 lbs
- Box Dimensions: 19″ x 13″ x 8″
- Full Pallet Quantity: 40 boxes
- Pallet Dimensions: 48″ x 40″ x 40″
- Data Sheet-U-Anchor 3800-S COATINGS (PDF)
- Product Guide – AP Guide Specification (DOCX)
- Detail Drawing – U-Anchor U3800, Mechanically Attached, Coatings (Butyl Fabric) (PDF)
- Detail Drawing – U-Anchor U3800, Mechanically Attached, Coatings (3 Course with Reinforcement) (PDF)
The U3800-S Coatings is attached by fastening through the roofing assembly into the structural decking with 2-12 approved fasteners. Depending on the roofing manufacturer’s requirements, the reinforcement type may vary, thereby changing the method of installation. Consult the coating manufacturer for proper application instructions.
Fastener selection is dictated by the system assembly, deck type, and the project engineer.
Refer to installation instructions and the specified roofing material manufacturer requirements before installing.
To securely mount your rooftop equipment to the U-Anchor, after its installed, the connection nut must be fastened to approximately 20-25 torque pounds.
Use a calibrated torque wrench during install to ensure appropriate results are achieved.
- Lightweight: 8 oz. (226 grams).
- Installs quickly, approximately rate of 12 per man hour.
- Installs on any surface from flat to vertical.
Results are base on plate performance only.
- Ultimate Load – Shear: 8600 lbs
- Ultimate Load – Tension: 4600 lbs
Test was performed in accordance with: ICC-ES AC467 Section 3.2
- Accepted – All Major Roofing Manufacturers
Individual deck assembly reports available upon request.
- Standard 20 Year Material Only Warranty