U-Anchor 2600 Coatings

The U-Anchor 2600 is a mechanically attached solution, consisting of a U-Anchor plate with a 3/8”-16 X 1 3/8” Stainless steel stud and flashing. The plate if fastened over the existing roofing to the structural roof deck. The factory supplied flashing is then sealed to the roof material creating a permanent seal. The flashing can be made from the same brand as the roofing material. 

Please specify a brand when possible. Nuts and lock washers sold separately. Alternate colors other than white are available, please contact us.
 

UAnchor2600Coatings-3.jpg

$42.50

Available for the following roofing manufacturers: 
Generic, Firestone, GAF, Garland, Tremco, Quest - HydroStop/United, Karnak, ER Systems, Kemper Systems, Conklin
 



Shedd  Aquarium pic Products Landing Page U-Anchor 2600 Coatings.jpg
Shedd Aquarium.png
U-Anchor 2600 Coatings.png

Testing

Testing-Photo-2-150x150.jpg

Disclaimer: The attached information represents tension loads or loads applied to the product in an upward direction, perpendicular to the roof surface. Roof assemblies must be secured in accordance with typical roof industry installation practices and attachment patterns specified in the individual test report selected. Third party test reports are available for both tension as well as shear for each roof assembly. Loads are listed in ultimate force without the inclusion of a safety factor. Allowable loads should be calculated using a safety factor consistent with ASCE7 and ASTM D6630. Actual safety factor identification and overall force load calculations are the responsibility of the qualified design professional of record for each project.


Videos